ABS set to 0 at begin of race

[Lezzam]

When I enter the pitlane or start a race my ABS setting reset itself to 0 and the traction control is set to 1.
When I set these settings to another value in the garage/setup and return to the track it’s zero and one again.

while on track I can adjust these values to the wanted numbers I want.

Does anyone recognise this behaviour?

 

[Phenix14]

I have a Fanatec Formula V2 wheel and since I have absolute values for TC and ABS bound in the rotary switches this could happen to me if I didn't pay attention to their position before leaving the pits...
Maybe you have a similar setup in your control bindings?

 

[Lezzam]

I have a Fanatec Formula V2 wheel and since I have absolute values for TC and ABS bound in the rotary switches this could happen to me if I didn't pay attention to their position before leaving the pits...
Maybe you have a similar setup in your control bindings?

Thank you, this was exactly what was the case. The rotary switches where bound to ‘set tc value’ and ‘set abs value’. I cannot remember I make this setting but.... now I know!