When booting up my pc, I have to unplug the displayport connection on my hp reverb otherwise my triple screens stay blank. I can safely reinsert the displayport after pc has booted up.
This is normally fine and I can switch between vr and triples gaming until a reboot is required.
I then have to climb out of my very snug simpit, walk round to back of pc and disconnect the displayport cable from reverb, reboot pc and reconnect reverb.
Is this likely an nvidia surround issue?
I tried fitting a displayport extension cable so I could easily disconnect the Reverb from within the pit but the Reverb doesn't seem to like extension cables.
Some long sessions switching between multiple vr applications does require a reboot to get things working nicely again and once I'm in the pit it's a right pita getting out just for a reboot.
Any suggestions?
This is normally fine and I can switch between vr and triples gaming until a reboot is required.
I then have to climb out of my very snug simpit, walk round to back of pc and disconnect the displayport cable from reverb, reboot pc and reconnect reverb.
Is this likely an nvidia surround issue?
I tried fitting a displayport extension cable so I could easily disconnect the Reverb from within the pit but the Reverb doesn't seem to like extension cables.
Some long sessions switching between multiple vr applications does require a reboot to get things working nicely again and once I'm in the pit it's a right pita getting out just for a reboot.
Any suggestions?
