Hi Guys
Having so much fun with this livery, looks so good on track but I did notice a tiny problem with rear and DRS wing logos.
Update details:
- Larger Pennzoil logo (DRS Wing)
- Replaced rear wing logo with Hass F1 Team
As some of you may already know, designing liveries on the Red Bull chassis can be a bit challenging.
If I were to place the rear wing logo at the back of the DRS wing then this would mirror over to the front nose where the warning hazards are. This is a bit of a setback due to CM default templates. There's nothing I can do about this and this would interfere with the overall design.
By placing the logos a bit lower actually looks pretty good, especially on track and I think it looks a whole lot better than having nothing at all.
Hi Guys
Wasn't happy with the previous wheel rim so I added a new design - all black wheel rim, gold and red center detailing with white OZ Racing logos. Also added rear wing sponsor.
As some of you may already know, designing liveries on the Red Bull chassis can be a bit challenging.
If I were to place the rear wing logo at the back of the DRS wing then this would mirror over to the front nose where the warning hazards are. This is a bit of a setback due to CM default templates. There's nothing I can do about this and this would interfere with the overall design.
By placing the logos a bit lower actually looks pretty good, especially on track and I think it looks a whole lot better than having nothing at all.