I am going to be building my own racing frame this december.
The picture below is what I am looking at doing/building, I am wanting to know if anyone could help me in which profile size to go for, 30mm or 40mm square?
When I was doing the artwork, I noticed there is only a slight difference in height between the two, which isnt a real problem, giving I am happy to raise or lower the seat as required.
Any help or suggestions would be greatly appreciated.
Thanks
The picture below is what I am looking at doing/building, I am wanting to know if anyone could help me in which profile size to go for, 30mm or 40mm square?
When I was doing the artwork, I noticed there is only a slight difference in height between the two, which isnt a real problem, giving I am happy to raise or lower the seat as required.
Any help or suggestions would be greatly appreciated.
Thanks