Use.. not much really averaged about 2 hours a week sometimes a bit more sometimes less. Had the wheel for about 3 and a half years.
Slip rings.. worked in inertial navigation systems,
learnt a thing or two about slip rings from the mechanical engineers. When I initially had a problem with my slip rings, stripped them down and found the concept to be virtually failure free, they were “very” dirty, re-set them, cleaned them properly, rechecked them a couple of months ago, still perfect, never had a problem with them at all.
A very good system, I think Simxperence abandoned them due to a knee jerk panic reaction, I actually wrote to them about it, as expected, totally ignored.
Accuforce .....will be seen independently from your shifters and pedals, it is also possible to use the spare mount to mount a no paddle shift wheel.
Simxperence... software comes with it also, I just use the wheel in isolation to the software, as it is able to be used with a pre program settings.
Coiled cable....... That can be used if you want to run
the wheel without slip rings or an after market wheel.
I have never used it, just using the spare hub on Fanatec wheels, again using the slip rings for usb transmission. There are a number of USB ports on the back for rev counters or usb after market wheel. ( a very versatile bit of kit this Accuforce )
Simxperence.. software can run chassis vibration, and motion rigs, plus a lot more.
