Hello!
I recently received my order for a custom simrig from motedis.
To my surprise, I just found out that despite the bracket and profile being the same type (40, Type I, 8 slot) - the angle bracket can't slide into the profile slot.
Here is the stuff I ordered:
- Profile: https://www.motedis.it/it/Profilato-alluminio-40x80L-scanalatura-8-tipo-I
- Bracket: https://www.motedis.it/it/Staffe-angolari-40-scanalatura-8-tipo-I
I do understand that I could break all the tabs, but seems like an inconvenient thing to do, considering they should fit just fine.
Did any of you ever found something similar?
I measured both the angle and the profile, and the dimensions are as expected. It's just that the small tab is something like 0.5mm bigger than what it should be.
I recently received my order for a custom simrig from motedis.
To my surprise, I just found out that despite the bracket and profile being the same type (40, Type I, 8 slot) - the angle bracket can't slide into the profile slot.
Here is the stuff I ordered:
- Profile: https://www.motedis.it/it/Profilato-alluminio-40x80L-scanalatura-8-tipo-I
- Bracket: https://www.motedis.it/it/Staffe-angolari-40-scanalatura-8-tipo-I
I do understand that I could break all the tabs, but seems like an inconvenient thing to do, considering they should fit just fine.
Did any of you ever found something similar?
I measured both the angle and the profile, and the dimensions are as expected. It's just that the small tab is something like 0.5mm bigger than what it should be.