Is someone using a Fanatec Club Sport Wheel? if so can you pls post your settings?
Thanks
Thanks
Has they changed something in ffb? Steering feels like s**t with v2, light centre/no proper forces or resistance in centre zone. Overall horrible rubbery feel. I prefer stiff steering with zero centre ffb-deadzone, there has to forces straight away when I start to turn the wheel. And earlier there was quite decent feel, but not nowadays.
I use 250 drivers and 176 firmware in wheel.
@Moxley6969
so i ran "WheelCheck 1.72", with 100 count, twice, got CSV file and used "LUT generator 0.15" for LUT file into CFG folder of AC and also edited the "ff_post_process.ini" file as per instructions.
[HEADER]
VERSION=1
TYPE=LUT
ENABLED=1
[GAMMA]
VALUE=1
[LUT]
CURVE=myfilename.lut
this is the CURVE from LUT GENERATOR (no clue/ idea what it means):
View attachment 147202
my wheel feels now completely "floaty" no resistance at all while driving, and only in LEFT and RIGHT HAND turns i get hits/ bangs in the wheel as if someone is hitting with a hammer very subtle hits...very strange and weird, wheel feels like good old days of "NO FFB". hmm.
and in game/ AC settings:
View attachment 147204 View attachment 147205
maybe my CSW V2 is on it's way out? or soon to say goodbye? do you set anything on the wheelbase itself? in the PRESETS?
@Moxley6969
my wheel feels now completely "floaty" no resistance at all while driving, and only in LEFT and RIGHT HAND turns
Fanatec CSP v2 and v3 = Brake Gamme in AC = 1.0? any recommendations or suggestions?
(i always have had it on 1.0 for/ because of linearity, correct?)
@Brandon Wright can you share your settings? Right now I'm using:
FF:100
SHo: 100
AbS: OFF
LIn: OFF
drI: OFF
For: 100
SPr: OFF
dPr: 030
Kerb Effects: "30"
Road Effects: "0"
Slip Effects: "0"
Understeer Enhanced ON
Brake Gamma 1.0
I tried a hundred times run the wheelcheck to generate the LUT, but generated curve never seems to be right.. so I leave the ff_post_process.ini default ( gamma 0.5 )
Anything I can do to make it better? I just bought my fanatec and still searching for the best setup..
If you're on a CSW you don't need the LUT. Your settings are pretty similar to mine, but I think with DRI set to off you're getting a heavily dampened wheel. I'd try turning that up a bit, the preferred setting is 3 which means it neither dampens nor accelerates the rotation but I usually prefer 1 or 2. I also do not like using the enhanced understeer, but I do add a touch of Road and Slip effects (around 10 I believe).
If i set DRI 1, 2 or 3 my wheel keeps rotating forever wih just a small touch.. like it's too light.. its crazy.
If i set DRI 1, 2 or 3 my wheel keeps rotating forever wih just a small touch.. like it's too light.. its crazy.
Shouldn't be like that. On 1 or 2 there's still some dampening to the wheel and it won't rotate more than needed.