Attaching NLR V3 and seat sliders - P1-X rig

[Lesthegringo]

All, I have yet to get all my stuff here but I have realised that I still have my seat sliders from earlier in my rig use, before getting the V3. When I build the P-X rig, I want (if possible) to be able to use the seat sliders again, and I can imagine that the best way would be to mount the V3 on the sliders, and not vice versa. My concern is the centre of gravity change of the seat sliding back and forth over the V3.

Has anyone done this? The seat sliders are the generic Sparco type available on Amazon, and in fact for a couple of years did duty in my old Alfa Sprint.

I don't have any of the hardware in front of me to help me visualise how to put it all together, the only vague plan I can think of is to fix a thick 'floor' to the underside of the rig and mount the sliders on that, and modify the original V3 brackets to fit the sliders. The trouble is I am not sure how much room is available. I'm also concerned about the overall seat height.

Any ideas or input greatly appreciated.

Cheers

Les