Brake pedal only goes to about 30%

bo1210 · Feb 6, 2019

Hey guys,

Windows 10, T300 RS wheel and T3PA pedals. This is a screenshot of the control panel with the brake FULLY pressed. The gas pedal and clutch go perfectly to 100%. I have uninstalled/re-installed the drivers and the wheel has the latest firmware. I switched out the T3PA with the pedals that came with the T300 and it did the same thing. No problems are showing in device manager. Asking here because I have a ticket in at Thrustmaster, but they are very busy and I'm not sure how long it will take for them to get back to me. Thanks in advance.View attachment 289960

bubbi_177 · Feb 6, 2019

sounds wierd but i have had some kind of the same problem with my thrustmaster t150 i just unplugged the wheel and shut down the pc then plugged in again and turn computer on then the wheel set it self up again and then it worked

mo86 · Feb 6, 2019

Looks like a wheelbase problem. Is it constant at 30% or is this the maximal value? Did you take a look at the rj11 connector and plug?

bo1210 · Feb 6, 2019

Already tried that. Thanks.

bubbi_177 said:
sounds wierd but i have had some kind of the same problem with my thrustmaster t150 i just unplugged the wheel and shut down the pc then plugged in again and turn computer on then the wheel set it self up again and then it worked