Hi everyone, could someone please help me setup my Dayton Puck tactile transducers. I bought four 8ohm version and bought this amp https://www.amazon.ca/dp/B0785JNBCM/ref=cm_sw_r_cp_apa_i_swBeFbGRZNHP6
Now what is best way to connect to computer. I plugged a 3.5mm to the Orange output on the computers IO output and other end to the amp. Where do I go from there? Thanks.
I tried using Simhub. But only one pick produced and rumble and I and I made difference if I did left or right test same puck rumbled? Thanks
Now what is best way to connect to computer. I plugged a 3.5mm to the Orange output on the computers IO output and other end to the amp. Where do I go from there? Thanks.
I tried using Simhub. But only one pick produced and rumble and I and I made difference if I did left or right test same puck rumbled? Thanks
