Hi,
I've installed the CSW v2.5 wheelbase onto my rig, updated the firmware. Everything is ok.
As the wheelbase is so new raceroom will not recognise it properly so my question is I know that you can change the controller file manually to a CSW v2 but can someone tell me how I do it?
This is just so I can set things like wheel rotation.
At the moment the game is recognising the wheelbase as a standard wheel.
The other thing is whenever I run the wheel properties from within Windows, the hard drive lights up for a little while but I'm not seeing the properties page. Works ok for the fanatec pedals but no response for the wheel.
Shall I try rolling back on the drivers and see if that makes any difference?
Windows 10 64 bit. Latest version of the fanatec drivers.
Thanks.
I've installed the CSW v2.5 wheelbase onto my rig, updated the firmware. Everything is ok.
As the wheelbase is so new raceroom will not recognise it properly so my question is I know that you can change the controller file manually to a CSW v2 but can someone tell me how I do it?
This is just so I can set things like wheel rotation.
At the moment the game is recognising the wheelbase as a standard wheel.
The other thing is whenever I run the wheel properties from within Windows, the hard drive lights up for a little while but I'm not seeing the properties page. Works ok for the fanatec pedals but no response for the wheel.
Shall I try rolling back on the drivers and see if that makes any difference?
Windows 10 64 bit. Latest version of the fanatec drivers.
Thanks.
