CM & CSM changes to ff_post_process?

Terry Rock · Aug 11, 2019

Is the auto installer for Content Manager overwriting a part of the ff_post-process.ini file in the Documents/AC/cfg/ff_pp file?
I started the sim this morning and my wheel went 'nuts', (buzzing and shaking) with the car just sitting in the pits.
It was not really 'drive-able'...since it continued rocking violently back and forth on track s...even going straight.
I exited went and did the LUT configuration and that restored it.
I then went into CM a bit later and loaded the recommended CSP (140...I believe) and again the wheel went nuts.
I again exited and on checking the PP file, it had the entire LUT setting missing.

Deleted member 197115 · Aug 11, 2019

CM settings overwrite manual config changes.
Either match them or make you manually modified file Read Only.

Terry Rock · Aug 11, 2019

Andrew_WOT said:
CM settings overwrite manual config changes.
Either match them or make you manually modified file Read Only.

I found the solution.
CM doesn't pick it up automatically.
You have to manually select LUT or GAMMA using the drop-down arrow, then point it to the.LUT file.
Thanks.

levin_ek · Apr 28, 2020

Hi,

That solved it!

Thanks!

random2k4 · Jul 1, 2020

Hey, I have the same issue. Where can I manually select the .lut file in CM?

irdo · Jul 2, 2020

can you exactly tell how you find the solution I have the same issue after applying lut

Stereo · Jul 2, 2020

In CM you enable a lut like this:

in general principle gamma should never be anything except 100%, and if you use a lut with a notch at the beginning (like the one in the screenshot) you need to set min. force to 0%.