DIY F1 Wheel: Advice about clutch pedals wanted.

James Robertson · Oct 16, 2015

I have recently bought an Ultimaker2 3D printer and decided that a good first project would to be create a replica f1 wheel that I can attach to my fanatec universal hub. I have been modelling the wheel in solidworks and have got to the point where I need to decide what to do about the clutch paddles.

I have ordered a Leo Bodnar Sli-f1 so I presume there must be some kind of electronic modules for the wheel mounted clutch paddles

Can anybody advise me on what I need?

I will get some pictures up of my build as things progress.

James Robertson · Oct 20, 2015

Deleted

Mark_McQ · Oct 20, 2015

I think the analog options for the SLI are potentiometers, or using hall effect sensors.

James Robertson · Oct 20, 2015

Thanks for the reply.

So presumably if I use potentiometers for the clutch paddles I can then calibrate their range of motion within the sli software?