Probably trying to do something impossible but here it goes...
Bought some led pilot lights as used in the 458 GTe dash etc. they only have two terminals 5v and gnd. Now I’m trying to figure out how I can steer them with Simhuband I was thinking about using some led library and the special gear part of the arduino sketch but I do not know where to begin. Would love to have red light when rpm is 0 and yellow when fuel is low.
Can you please guide me how to get this done? I’m stuck...
Anyone? Point is that i’m Not sure how to switch the led on and off with just two terminals.
Please let me know if you have experience with using hardware outside of the usual stuff that is supported by simhub out of the box
Any idea or guidance how to start is welcome