W
Wido Rossen
-
Wido Rossen
Looks pretty neat this wheel.....and it`s wireless.
Last edited by a moderator:
...then realised that half way on the cable there's a plug, made sure this was connected well and voila, the shifter now worked properly again, haven't had the issue since and it's been a couple of weeks now.
hi fritz i had similar problem in h shifter mod the hall sensor was dirty so i took it apart and gave it a good clean and that fixed it ,but i would not advise it if it is still under warranty ,you also might have a different problem in the cables or joins
hi fitz my problem was actually worse than your,s ,mine was going from 3rd too first and from 6th too reverse destroyed a couple of my clubraces here,anyway firstly i used a rag that worked for a few days ,but then i used a contact cleaner ,i used it on both sides of the hall sensor and really gave the socket area where the magnet is in the shaft a good cleanThanks. Which plug are you referring to? I have a simple phone jack plug on either side to connect to the wheel. Fanatec said they've had problems with these cables but I've gone through 3 now and I don't really think it's the cable.
Thanks. I'm pretty sure it's dirty in there, but apparently I'm still under warranty so unless Fanatec green lights me opening the thing up I'll wait for their next step. What did you use? Compressed air and soft rag?