FANATEC static shifter paddle has been modified to push-pull shifter
- Thread starter BigShot
- Start date
Mate that is awesom!!
How did you disassemble the shifter on the left side?
Can you post pictures of how you connect those two parts and how you solve the cablemanagement?
Thank you very much for the idea!! Will try to do that too in the future!
How did you disassemble the shifter on the left side?
Can you post pictures of how you connect those two parts and how you solve the cablemanagement?
Thank you very much for the idea!! Will try to do that too in the future!
Upvote
0
Mate that is awesom!!
How did you disassemble the shifter on the left side?
Can you post pictures of how you connect those two parts and how you solve the cablemanagement?
Thank you very much for the idea!! Will try to do that too in the future!
I just disassembled the cable connected to the switch of the left shifter and pulled it out to the other side.
And the left shifter part was connected using the inner bracket used for the 20mm aluminum profile.
The disassembled cable is short, so you need to extend it.
The most important thing is that the scope of the shifter's operation is too large, so you have to narrow it down. I usually used insulation tape.
Attachments
Upvote
0
