Since the FFB update, the Fanatec site for FFB settings is a little stale. Searching here, I don't see where anyone has posted their settings. So, if you have a good FFB setup for AMS2 and the CSL Elite or any other Fanatec, please consider sharing both the wheel settings and the FFB in game values. Thanks!
FFB Settings for Fanatec CSL Elite in AMS2
- Thread starter thespeedracerx
- Start date
I use a CSl Elite and the fanatec settings are a bit rubbish. I use the Default+ and the gain set to 60 with the other ingame settings turned down low. Individual cars respond differently so I adjust per car - usually around 70-80%. On the wheel, I have ffb @100%, Force about 70-80 and the shock and effects down around 40-50. Damper on 100, and brake force to suit your own preference - I have the Elite LC set to 40%.
Thank you for your reply. Fanatec's recommendations are definitely rubbish. I've combed the Reiza forums and see a lot of discussion about the rf*ktor and then later the Default+ custom file. Is that where you got the file? Have you tried the latest rf*ktor 5.1.1 yet? Once I get a hold of the Default+ text file, I'm going to give yours a try.
I did try one of the rfktr type modded files a while back but it was way too noisey, loads of wee bangs and smashes that felt bad. I stick, now, to the defaut + game setting and adjust as I go. All I want is force that feels weighted and predictable. Also, the DRI setting acts as a damper, recommended setting is -2, but for older cars that require a bit of lock to lock correction, + values help, but you lose a bit of damping - think of it as powersteering settings, more or less to suit.
CSL
Sen: Auto
FF: 95
Force: 80
Spring: 80
FEI:30
DRI: -3/+2 (User preference, per car)
DPR:100
BRF: 40
Sen: Auto
FF: 95
Force: 80
Spring: 80
FEI:30
DRI: -3/+2 (User preference, per car)
DPR:100
BRF: 40
This is a really nice ffb setup, I just tried it myself!
