F1 2010 G27 behaving badly

F1 2010 The Game (Codemasters)
Alright guys, wondering if this happens to anybody else...

I expect like most people, when you first switch on your G27, its does its little calibration routine and the comes to rest. However, if I have my G27 turned on when I load up F1, it does a couple quarter turns, centres at the 12 o'clock position, but then starts rocking (kinda between 11 and 1 o'clock position) and doesnt stop until I grab it and hold it steady. If I give the wheel another little tweak, it will do it again.

This doesnt stop the wheel working normally in game, and after a race, things are normal, even if I tweak the wheel it doesnt do this funny rocking.

I dont remember it doing this before, and I cant think of anything ive changed. Doesnt happen when loading Dirt2 for instance.

Anyone else experienced this?
 
Well not that i wish problems on people, but I'm glad I'm not alone. I was worried it could have been the beginning of the end for my wheel!

Maybe if any of us figure out what's going on we should update this thread.

* with hind-sight maybe a mod could make my thread title more specific to the problem please?

Cheers.
 
You need to have no profile loaded and instead, configure the global settings. If you setup a profile for F1, then it does go jerky. The MOMO wheel does this too.

If it still jerks, then reset global properties, that should remedy it. Also, turn down center spring that can cause it too possibly.
 
My G27 does not do this, as I do not load a profile for F1, I leave it set to default profile.

You have to have the Global Device Settings being used for F1 and not use a profile.

Settings that I use are:

Overall Effects strength 94%
spring effect strength 0%
Damper effect strength 0%
enable center spring in force feedback games = Checked ON
center spring strength 0%
Report combined pedals = checked OFF
degrees of rotation 200%
Allow game to adjust settings = checked ON

If you have a profile for F1 2010, delete it.

If it still is a problem, reset both Global device settings and Global profiler settings.

This fixes the issue for me, My G27 does not do perpetual left to right to left etc jerky stuff. If I pull the wheel to one side and release, it settles in the middle.

I hope this fixes it for you. I have had this issue before and it has always fixed itself when I did the above process. You do not have to have the first 3 settings at 94%, 0% & 0% though. If I set the center spring %age, the jerky effect starts to happen in proportion to the center spring %age.
 

Latest News

What is the reason for your passion for sim racing?

  • Watching real motorsport

    Votes: 480 69.9%
  • Physics and mechanics

    Votes: 291 42.4%
  • Competition and adrenaline

    Votes: 317 46.1%
  • Practice for real racing

    Votes: 144 21.0%
  • Community and simracers

    Votes: 187 27.2%
Back
Top