G29, LUT Generator and MAX Count

[dphodgdon]

A question for G29 users...when you run the LUT Generator, what "Max Check" value do you use? The suggested value is 50 or more, I ran it again a couple of days ago using 350 and there is almost no dead zone and I find it much easier to change direction in high speed sections, such as the esses at Riverside. Is there a maximum value?

 

[fleezy]

i'm fairly certain the "max" indicates the frequency of degrees checked in rotation, and therefore i would assume a higher number would dictate a smaller deadzone. perhaps there is no difference between 100 and 350 for the g29? i did 75 and there is a small deadzone, which is fin to me