I've got a (very) cheap and bad wheel(Hama Thunder V5), the game seems to be reading the raw data of my pedals not direct input(as seen in DIview), is there any way to change this?
EDIT: SOLVED!:
The solution is as follows: access your: C:\Users\(username)\Documents\Assetto Corsa\cfg and open the "Controls" file with Notepad, look for these lines:
[THROTTLE]
JOY=3
AXLE=1
MIN=0.0001
MAX=-1
[BRAKES]
JOY=3
AXLE=1
MIN=-0.0001
MAX=1
GAMMA=1
Decreasing the "MAX" values will result in configuring a deadzone at the ends of the axis,
Decreasing the "MIN" value of "THROTTLE"(usually to negative number) will add a deadzone at it's start
Increasing the "MIN" value of "BRAKES" will add a deadzone at it's start
Here's an image of my fix and values{Note that putting 0.9 at "MAX" means I've added a 10% deadzone, (1-0.9)*100=10}, I've added a visual representation of the axis for those more visually inclined.
EDIT: SOLVED!:
The solution is as follows: access your: C:\Users\(username)\Documents\Assetto Corsa\cfg and open the "Controls" file with Notepad, look for these lines:
[THROTTLE]
JOY=3
AXLE=1
MIN=0.0001
MAX=-1
[BRAKES]
JOY=3
AXLE=1
MIN=-0.0001
MAX=1
GAMMA=1
Decreasing the "MAX" values will result in configuring a deadzone at the ends of the axis,
Decreasing the "MIN" value of "THROTTLE"(usually to negative number) will add a deadzone at it's start
Increasing the "MIN" value of "BRAKES" will add a deadzone at it's start
Here's an image of my fix and values{Note that putting 0.9 at "MAX" means I've added a 10% deadzone, (1-0.9)*100=10}, I've added a visual representation of the axis for those more visually inclined.
Last edited:
