Save Game I need help with a racing flywheel 2019-11-17

[rock5tar60]

rock5tar60 submitted a new resource:

I need help with a racing flywheel - Help

Hi there I am woried that if I try and put the racing flywheel in myself the car will not work or it will blow up knowing my luck.

If you could help I will be very greatful

Read more about this resource...

 

[Wolfox]

If it's the flywheel's function, its a lighter flywheel than stock, decreasing engine mass and inertia, giving more tighter throttle response, quicker gear changes, etc. The engine will also vibrate more because of this but thats normal. Just remove the inspection cover, drive gear and clutch, replace the flywheel and put it all back together again. Easy peazy.

 

[alexebe]

If it's the flywheel's function, its a lighter flywheel than stock, decreasing engine mass and inertia, giving more tighter throttle response, quicker gear changes, etc. The engine will also vibrate more because of this but thats normal. Just remove the inspection cover, drive gear and clutch, replace the flywheel and put it all back together again. Easy peazy.

I remember when there was no inspection cover and I gad pull the whole engine out, then pull the gearbox out, then I had to pull the drive gear off and then I had to pull the clutch out then I replaced the flywheel out and put everything back on it was really hard

 

[Wolfox]

You don't need to yank the entire trans out. Just unbolt the bolts holding the inspection cover (four top bolts) and remove the drive gear and clutch, replace the flywheel and put it back together.

 

[alexebe]

You don't need to yank the entire trans out. Just unbolt the bolts holding the inspection cover (four top bolts) and remove the drive gear and clutch, replace the flywheel and put it back together.

yeah I was talking about before the cover could be removed

 

[Wolfox]

ah i see

 

[Vexousek]

I help you