Warren Dawes
Premium
More hardware confusion for me.
I have just received my new Leo Bodnar G25 adaptor cable to allow direct connection of the Pedals to USB. I had been advised that this would help improve sensitivity among other benefits.
It's this one:
http://leobodnar.com/products/DFPG25conn/
However, something seems strange.
I plugged the pedals into the new cable, connected the USB to my PC, all seems to load ok, but when I go into the calibration screen, I find that the Accelerator is reversed compared to the Brake and Clutch. The Accelerator is at full travel without any movement, and goes to nil reading when fully depressed. The Brake and Clutch work as expected.
Has it been wired wrong??? I received no additional instructions or software with the cable, and I can't see anything at the Leo Bodnar website to advise if I have to do anything special with the setup.
Looking for more help, please.
I have just received my new Leo Bodnar G25 adaptor cable to allow direct connection of the Pedals to USB. I had been advised that this would help improve sensitivity among other benefits.
It's this one:
http://leobodnar.com/products/DFPG25conn/
However, something seems strange.
I plugged the pedals into the new cable, connected the USB to my PC, all seems to load ok, but when I go into the calibration screen, I find that the Accelerator is reversed compared to the Brake and Clutch. The Accelerator is at full travel without any movement, and goes to nil reading when fully depressed. The Brake and Clutch work as expected.
Has it been wired wrong??? I received no additional instructions or software with the cable, and I can't see anything at the Leo Bodnar website to advise if I have to do anything special with the setup.
Looking for more help, please.