Nextion editor wont upload to display

[TheRaceIsOn]

Hey
Got my Nextion NX4827T043 4.3 and haved tried to connect it to the pc like this:

TX->RX
RX->TX
GND->GND
5v->5v

I haved used this as a guideline:

When i try to upload a template via Nextion simhub nextion editor i got this error.

Do u know what i am doing wrong or have to chance?

 

[Rostovic]

Think you have to instal a driver for the USB to TTL module , had the same issue a while ago .

 

[TheRaceIsOn]

In fact, I do not use a TTL module at all. I connect the display directly to the arduino table. Maybe you can not do that at all?

 

[Rostovic]

Not realy sure , i used on of those modules
Perhaps this helps
Nextion Display · SHWotever/SimHub Wiki · GitHub

 

[TheRaceIsOn]

I will order it now
Thanks for your help man

 

[Carruseles]

Hey
Got my Nextion NX4827T043 4.3 and haved tried to connect it to the pc like this:

TX->RX
RX->TX
GND->GND
5v->5v

I haved used this as a guideline:

When i try to upload a template via Nextion simhub nextion editor i got this error.




View attachment 433603


Do u know what i am doing wrong or have to chance?

Hi bro. When you have this issue you must disconect the nextion and then conect it again (with the program on) check the com5 again and press upload again and....ready

 

[TheRaceIsOn]

Thanks boiz
It works now

 

[BroZ.-.]

What u did, I have exactly same problem

 

[TheRaceIsOn]

Bad news bro. I actually did not get it fixed yet : /

I will tell you if i fixed it

 

[TheRaceIsOn]

What u did, I have exactly same problem

Have you found a solution?

 

[BroZ.-.]

I

Have you found a solution?

I replaced with a new nextion screen and it works. lol

 

[TheRaceIsOn]

Thanks

 

[Sim Racing Addict]

Make sure SimHub is off, and that you have drivers installed for your TTL module.
Plugging and unplugging also helps.

 

[jimmie]

Hey
Got my Nextion NX4827T043 4.3 and haved tried to connect it to the pc like this:

TX->RX
RX->TX
GND->GND
5v->5v

I haved used this as a guideline:

When i try to upload a template via Nextion simhub nextion editor i got this error.




View attachment 433603


Do u know what i am doing wrong or have to chance?

same thing happened to me. it says "nextion not found".
1.first just try unplugging and plugging your nextion. this has been known to work.

2. If that doesn't work you probabbly have the wrong port identified. To check the com port. ...Go to device manager. Click on ports. look at the ports com 1,2, 3,4 or what have you. Unplug your nextion to find the right port( the one that disappears is your port. If you use another usb port. Use the same process to find the right com port again.
once again unplug and replug.... see if that works (if you have the right port)
if not make sure you have the right port by using the method above and next unplug and replug. then try to upload.
This is how I solve it every time mate.