"Paint" on Track

[Ralf Ääro]

Hello

is there an "easy" way of painting lines on the track?
And I dont mean Textures with lines on it, like the default Tarmac Texture.

 

[banger]

use a wall, flating the center nodes.and move to position

 

[Ralf Ääro]

use a wall, flating the center nodes.and move to position

I tried that, but it seems, that there are problems with rendering, because sometimes the "painted lines" are disappearing into the ground. Not always, just at some Parts.

 

[chub_pearson]

I tried that, but it seems, that there are problems with rendering, because sometimes the "painted lines" are disappearing into the ground. Not always, just at some Parts.

That will be where they are too close to the ground at that point. AFAIK the line should be 2 cm+ above the track surface. Try adding extra control points where it's too low and raising it up a bit.

 

[Ralf Ääro]

That will be where they are too close to the ground at that point. AFAIK the line should be 2 cm+ above the track surface. Try adding extra control points where it's too low and raising it up a bit.

I think thats working but, its VERY tricky to do that and it takes me hours just for some lines

 

[still_bacon]

If that is taking too long to do, then the best option is to create a custome texture with the lines on it.

You would never have this problem then.