Cars Praga R1T EVO (Data & Skins) V 1.3

[Breanuts]

Breanuts submitted a new resource:

Praga R1T EVO (Data & Skins) - Turbocharged version of the Praga R1

This little project started off as a one skin only thing, but little did I knew it became an obsession of mine for the past few months. Also note, this is not the new R1T, but the older version.

It is powered by a turbocharged version of the Renault-Alpine F4R engine in the R1 with an output of 380 bhp and 410 Nm of torque. The final gear ratio has been tweaked slightly to accommodate the engine upgrade, as well as ABS and TC are available as well. The remaining gear ratios, tyres and aero...

Read more about this resource...

 

[Breanuts]

Breanuts updated Praga R1T EVO (Data & Skins) with a new update entry:

Tweaked data and skin

Quick fix:

TC and ABS is removed based on the official Praga brochure and drivers' testimonies. turbo boost is now adjustable at 80% boost at default, pretty close to the base 330bhp boost map, likewise at 90% and 100%.

The 84 VR Motorsport skin received a small fix.

Read the rest of this update entry...

 

[Breanuts]

Breanuts updated Praga R1T EVO (Data & Skins) with a new update entry:

Revisions made to engine performance and gear ratios

Version 1.2 changes:

- Adjusted engine power curve
- Revised turbo boost to replicate ALS
- Tweaked and added final gear ratios
- Adjustable steering assistance
- Reduced fuel consumption to meet Praga's estimated 45-60 minute single full fuel tank run time.

Read the rest of this update entry...

 

[gearwhine]

As hard as i try i cannot get this mod to work. Ok, i have made a copy of the car, changed the file name to above and emptied the new unrapped file into the new folder. Tried in different ways and no joy. I know its me at fault but i cant make it happen. Any advise for a moron?

 

[jameshayman]

As hard as i try i cannot get this mod to work. Ok, i have made a copy of the car, changed the file name to above and emptied the new unrapped file into the new folder. Tried in different ways and no joy. I know its me at fault but i cant make it happen. Any advise for a moron?

same here

 

[Breanuts]

As hard as i try i cannot get this mod to work. Ok, i have made a copy of the car, changed the file name to above and emptied the new unrapped file into the new folder. Tried in different ways and no joy. I know its me at fault but i cant make it happen. Any advise for a moron?

Did you made a copy of the ks_praga_r1 folder with all the contents inside and rename it to ks_praga_r1t_evo?

 

[gearwhine]

Yes i did. When i check the folder it grows to 270mb when add your files and if i am not mistaken sits in the folder alongside the original file. I have even tried merging files manually. I am obviously doing something wrong

 

[Breanuts]

Yes i did. When i check the folder it grows to 270mb when add your files and if i am not mistaken sits in the folder alongside the original file. I have even tried merging files manually. I am obviously doing something wrong

Of course. The copied folder should be the same size as the original. Because you're essentially recopying all the skins and as in your original praga folder. You'll have to do your own housekeeping in the skins folder from here on.

*Allow the files to be rewritten in the renamed folder.

 

[gearwhine]

OK, problem solved. I don't know what i was doing wrong but worked this time round. Probably manual folder naming didn't help. Anyway, thanks for the help and you have done a fine job adding much more exciting physics to this car.

 

[Jonattan]

Does anyone can upload a link with a ready to go car?, I can´t find the original one to then update with this... if someone can zip the car folder with all done, it can be much appreciated... or at least point where to download the R1?

Thanks!

 

[Hoksu]

Try buying the Tripl3 pack DLC.

 

[William Crudup]

Car is not showing up in Content manager? I followed the instructions. Please help.
Thanks in advance.

 

[Azorath]

You need to have the Assetto Corsa -Tripl3 Pack first before installing this mod.


You need to specify its a DLC pack for people like me, I literally searched for it a while before finding out it was a dlc I own already lol

 

[smilinreese]

Ok, so i have a quick question. I have done everything you said, and then ran AC, but it still call the car just R1. Is that normal? Same name, just different details? Thanks

 

[Breanuts]

Breanuts updated Praga R1T EVO (Data & Skins) with a new update entry:

Addition of snorkel to No.84 car as well as minor updates

Newly added features (Mostly CSP):

• No.84 VR Motorport skin gets snorkel thanks to ben32star
• Re added ABS and TC
• Added new BrakeDiscFX
• Tweaked turbo sound.

Read the rest of this update entry...

 

[fostrike]

I can't see the new snorkel in VR but in the CM showroom is present.
Could be the LOD???

 

[Billy Pilgrim]

Thanks for sharing this mod.

You explain: "this mod comes with three engine boost modes of 330bhp/370Nm (80% boost at default), 360bhp/390Nm (90%) and the full 380bhp/410Nm (100%)."

Is there anything you have to do while driving with regards these boost modes, like press a particular button?

 

[Andy Tomalin]

hello, I have followed them instructions, and have both folders named correctly and all files copied, but I cannot see the car in AS when I go to Praga - any ideas? Thanks

 

[Mattaroony]

As hard as i try i cannot get this mod to work. Ok, i have made a copy of the car, changed the file name to above and emptied the new unrapped file into the new folder. Tried in different ways and no joy. I know its me at fault but i cant make it happen. Any advise for a moron?

I know its late but i found that copying the original then banishing it to another drive then just have the evo in Assetto Corsa worked

 

[RubyOnRails]

Does this still work? I think i did it correctly shows up in CM but it has a fix car button next to go. And if i try and use it complains about damaged LODs. I tried using the fix button but that also doesnt work.