Has anyone mounted this on their rig with motion? How is it? What mount did you use?
I have mine attached to a motion rig w/ 150mm of travel and a strong motion profile. After a month or two of use, the monitor has not (yet) caught fire, as the user manual suggested it might
My mount has turned out to be very effective at stopping the monitor from wobbling and flopping around.
@nerdthewise has the same monitor mounted to a non-motion rig, and he had to do similar bracing for the sides of the monitor to stop it from flopping around when he'd kick the clutch or brake pedals!
I forget which threads everyone's pictures are in... I'll re-attach mine here.
Amazon:
VESA tilt mount:
https://www.amazon.com/gp/product/B0069LPT0A
(Note that I mostly perform tilt adjust via my aluminum extrusion once during assembly and leave it there locked, I was just looking for a low-profile bracket and this seemed to be a good match.)
Misumi:
2x HFSLB8-4040-575 (40x40x575mm vertical pillars, black)
2x HFSLB8-4040-160 (40x40x160mm forward/back adjust pillars, black)
1x HFSLB8-4040-458 (40x40x458mm cross beam, black)
2x HFSB5-2020-355 (20x20x355mm support beams, black)
2-4x SHPTBD8 (40x80mm L-bracket for attaching vertical pillars to my 80mm-tall wheel deck)
4x HNTF8-5 (40x40mm profile drop-in T-nut, with 5mm threading for mating to 20x20mm profile brackets, to attach the support beam brackets to the vertical pillars)
8x HBLSSB5 (20x20mm L-brackets... 2x2 hold the two supports to the 40mm profile, 2x2 form a tight sandwich around the bottom monitor bezel, with some rubber underneath and black gaffer tape to reduce shock/vibration and to prevent scratching the monitor bezel)
2x HFCB5-2020-B (20x20mm end cap w/ set screw, black)
2x HFC5-2020-B (20x20mm end cap, black)
(and black 40mm end caps, if you want them)
8020.net:
4x 40-4295 (slotted bracket for attaching the VESA mount to the cross beam)
8x 40-4332 (for joining 40mm profile - for this application, I recommend these over other brackets, as they seem to withstand rotation well... this lets you use them as a tilt-adjust on the main cross beam... in my photos you see I used 4x of these and 4x of another type that don't perform as strongly)
Additional thoughts:
1) I'm very happy with the mount, and I'm not nearly as concerned about the monitor breaking now
2) The monitor location is pretty ideal, and I have a couple inches of adjustment in each direction, plus tilt, should I want it.
3) I get motion sickness with the monitor this close to my face and a strong motion profile. I didn't get this when I was driving in front of a projector screen, much further away. The combination of having the monitor so close, and having it move with the rig... well, in theory it is ideal, because it matches the car motion, but in practice my eyes have a hard time staying focused on the physically moving screen and I get sick! My personal solution is to run a reduced motion profile when using the monitor (filter out big, sweeping motions and retain jolts/accelerations), and full motion in VR.
I believe
@diablo2112 has a very similarly designed mount to mine, and
@HoiHman has a different design which you can see in his hardware showcase thread in this forum.