sfx 100 push pull mod
- Thread starter wingert
- Start date
the parts are a standard one piece shaft collar 28/48mm, increased the inner diameter to 30mm and 6 x M5x120mm screws with nuts.
You have to drill 5,5 mm through the slider and make the same boring with a 3D printed template into the collar.
Alternative you make your own slider with the integrated boring.
You have to drill 5,5 mm through the slider and make the same boring with a 3D printed template into the collar.
Alternative you make your own slider with the integrated boring.
Upvote
0
thanks for sharing your works, it is what i was looking for.
for those they are interested in the files here is :
www.thingiverse.com
for those they are interested in the files here is :
sfx 100 push pull slider + collar by jual
push pull slider + collar for the sfx100 project
www.thingiverse.com
Upvote
0
Witaj Ericu,dzięki za udostępnienie swoich prac, to jest to, czego szukałem.
dla zainteresowanych plikami tutaj jest :
sfx 100 push pull slider + collar by jual
push pull slider + collar for the sfx100 project
Ich habe gerade nach deinen Angaben ein Zusatzservo für den SFX 100 gebaut, umgebaut von 100mm auf 200mm. Das Servo soll an der TL auf der Rückseite sein. Ich suche jetzt nach Hilfe, wie ich dieses Servo so einstellen kann, dass es in SFB funktioniert. Könntest du mir bitte helfen?
Upvote
0
You say it’s Standstd. But it’s a part younprinted. I’d be Very helpful if you could Pleae upload it or give a link to get it. The one the guy posted, the slider is way too big for 100x100 and the collar is also way to big. Yours is circular with more than 2 bolts. Please please please post
Upvote
0
