Shader Problems

[Corey Stannard]

Hi, I keep getting this error when trying to boot the game.

---------------------------
Fatal error - the program will exit
---------------------------
DGPUShaderManager:MakeObject(data/renderer/shaders/dyn_standard_v.cg): can't create CG vertex shader program
The compile returned an error.
data/renderer/shaders/dyn_standard_v.cg(62) : warning C7011: implicit cast from "float4" to "float3"
(2886) : fatal error C9999: InitHAL failed
---------------------------
OK
---------------------------
Thanks, Corey.

 

[boomer541]

what is your system info? OS, graphics card etc.
Sounds like equipment problem but can't help without more info.

 

[Corey Stannard]

GTX960, Intel I5 4460, Windows 10, 8GB Ram

 

[Corey Stannard]

what is your system info? OS, graphics card etc.
Sounds like equipment problem but can't help without more info.

GTX960, Intel I5 4460, Windows 10, 8GB Ram

 

[boomer541]

You have a good graphics card so should work depending on which version of racer you are using.
If you haven;t tried version 0905 i would recommend you try it as it should work fine on your system.

 

[Corey Stannard]

You have a good graphics card so should work depending on which version of racer you are using.
If you haven;t tried version 0905 i would recommend you try it as it should work fine on your system.

That one says i have a Insufficient Graphics card to load cubemap?

 

[Harey]

That one says i have a Insufficient Graphics card to load cubemap?

Have you tried an older graphics driver?

 

[boomer541]

Your graphics driver could be the problem like Harey said.

 

[Mr Whippy]

I've run Racer in Win7 on a 1080.

I think I tried Win10 with the 1080 too.

Not sure on which drivers.

I was running RC5c.


I'm not sure on driver versions, but afaik Racer was supporting modern OGL versions and OGL is still fully supported on Nvidia stuff afaik.

Hmmm