Simucube 2 + P1X cable management

Hi,

Does anyone have any good solutions for tidying the too short power cables from the power supplies?

I'm using the front mount version

Please share :thumbsup:

Thanks
 
I´ve seen the ziptied to the uprights of the wheeldeck.
But that´s more Steampunk than tidy. :mad:

My powersupply ( singular) for the SC2 pro is just lying under the pedaldeck.
But the second revision has amuch longer powercord, so the best bet for you would be the extensions above.

MFG Carsten
 
Upvote 0
Mine are attached to the bottom of the uprights with 3D printed retainers. The cables are then stuck into the profile channels and covered with channel strips.






gallery_34981_4626_112164.jpg
are attached to the bottom of the uprights with 3D printed retainers. The cables are then stuck into the profile channels and covered with channel strips.
 
Last edited:
Upvote 0
  • Deleted member 197115

Even R1 works fine with 50cm extension cables as you add length to whatever stock cable is. I don't think you need extension on R2, should be long enough already.
There is a good quality one
 
Last edited by a moderator:
Upvote 0
Back
Top