Hi,
I had some problems with my T3PA Thrustmaster Pedals. The break input did not work properly (it was just flickering) and also the throttle pedal gave some break input. Cleaning the the potentiometer helps with this sometimes, but not for me. I found another solution:
The main switch (see picture) needs some pressure to work (I can't explain why). The at the bottom of the switch are those little solderingpoints. They have to sit on the plastic so there is some pressure on them. After putting it in place and tighten the screw everything worked just fine again.
Maybe this can be found on google when someone searches for help with the same issues
Kind Regards
I had some problems with my T3PA Thrustmaster Pedals. The break input did not work properly (it was just flickering) and also the throttle pedal gave some break input. Cleaning the the potentiometer helps with this sometimes, but not for me. I found another solution:
The main switch (see picture) needs some pressure to work (I can't explain why). The at the bottom of the switch are those little solderingpoints. They have to sit on the plastic so there is some pressure on them. After putting it in place and tighten the screw everything worked just fine again.
Maybe this can be found on google when someone searches for help with the same issues
