Hi everybody!
I have this annoying issue from time to time..when I plug my t500 to my Pc sometimes after the automatic calibration the wheel is not centered. If I tried to allinge it perfectly on the center I can see from the control panel wheel section that is around 44.5 degrees instead of 50.0. So I do remember and read on the office site than you can reset the value to the correct 50.0 in this way
Make sure that your racing wheel is perfectly centered ; while holding it in this position, press the START, SELECT & MODE buttons simultaneously (SE, ST & MODE buttons on the GT wheel; BO, WET & MODE buttons on the F1 wheel).
I have always used this tips but now the problem is this.. I'm using another wheel different from the original Thrustmaster Ferrari F1 replica wheel.. So I'm not able to push any button but the MODE one.. Is there any other way to fix this? It's a pain in the neck if every time I have to unmount my new wheel and put the original one just to calibrate it.. Thank you in advance for any help!
I have this annoying issue from time to time..when I plug my t500 to my Pc sometimes after the automatic calibration the wheel is not centered. If I tried to allinge it perfectly on the center I can see from the control panel wheel section that is around 44.5 degrees instead of 50.0. So I do remember and read on the office site than you can reset the value to the correct 50.0 in this way
Make sure that your racing wheel is perfectly centered ; while holding it in this position, press the START, SELECT & MODE buttons simultaneously (SE, ST & MODE buttons on the GT wheel; BO, WET & MODE buttons on the F1 wheel).
I have always used this tips but now the problem is this.. I'm using another wheel different from the original Thrustmaster Ferrari F1 replica wheel.. So I'm not able to push any button but the MODE one.. Is there any other way to fix this? It's a pain in the neck if every time I have to unmount my new wheel and put the original one just to calibrate it.. Thank you in advance for any help!
