TH8 RS 3D printed short shift plate

[Hor-hay]

I've modeled and 3D printed myself a short shift plate with 7th gear blocked off. Did require a small amount of filling.

If anyone wants the model I'll upload it to the download section I'm guessing, can't upload here.

 

[Insert Coin]

Yes please

 

[Moxley6969]

Upload it to Thingiverse, then post a link.

 

[Hor-hay]

Frig, can't upload it to the downloads section, I'll check out thingiverse...

 

[Hor-hay]

does this work, uploaded as a zip.
http://www.racedepartment.com/downloads/th8-shifter-short-shift-plate.14531/

 

[Moxley6969]

Higher poly would be better imo. But looks ok for the most part.

Yes support will very much be needed.

 

[Hor-hay]

Higher poly would be better imo. But looks ok for the most part.

Yes support will very much be needed.

I don't know much about 3D printing, I'm more of an animator. Just got it printed through 3D-hubs, worked fine. Printed in ABS with 20% fill.

 

[Moxley6969]

Higher poly = better details.....Im surprised the printer didn't pick up that wire mesh, but either way. Just a note for next time, a Higher poly wont ever really hurt anything, Except if its a MONSTER of a model and then yes a Super High poly count will make the file excessively large and be a bit heavy on resources.

 

[Hor-hay]

Higher poly = better details.....Im surprised the printer didn't pick up that wire mesh, but either way. Just a note for next time, a Higher poly wont ever really hurt anything, Except if its a MONSTER of a model and then yes a Super High poly count will make the file excessively large and be a bit heavy on resources.

Thanks for the tip, if anyone has issues I'll re-upload a higher poly version.

 

[Hor-hay]

lol found this on thingiverse, more options, smaller too so might cost less to print.
http://www.thingiverse.com/thing:1015120

 

[PicoBp]

lol found this on thingiverse, more options, smaller too so might cost less to print.
http://www.thingiverse.com/thing:1015120

This one's not a short-shifter plate, but just a normal replacement.

 

[Hor-hay]

This one's not a short-shifter plate, but just a normal replacement.

He has long and short plates.

 

[MaXKiLLz911]

lol found this on thingiverse, more options, smaller too so might cost less to print.
http://www.thingiverse.com/thing:1015120

I like yours better...