Hi All,
Currently done a build of AMstudio from Utube and i have followed everything shown but for some reason my display keeps cutting out, I have been told that the Arduino may not be keeping up with the data transfer rate (BAUDS setting) I have tested quite a few different rates but still no luck. Looks like its loosing power as it fades then goes out. Im using a 4 mt usb cable but have tried a short one and still same issue. Not using a USB hub, does the problem lie in the drivers of windows ??
comes up as a USB serial 340
link to the build is
any help is greatly appreciated.
Currently done a build of AMstudio from Utube and i have followed everything shown but for some reason my display keeps cutting out, I have been told that the Arduino may not be keeping up with the data transfer rate (BAUDS setting) I have tested quite a few different rates but still no luck. Looks like its loosing power as it fades then goes out. Im using a 4 mt usb cable but have tried a short one and still same issue. Not using a USB hub, does the problem lie in the drivers of windows ??
comes up as a USB serial 340
link to the build is
any help is greatly appreciated.
![Luca [OT]](/data/avatars/s/3235/3235113.jpg?1697196734){kind=avatar}