With the release of the new Evo editions of the Ferrari and AMG, which are in essence that same as their non-Evo editions in setting up. You might want to grab the AMG Nürburgring setup for the AMG Evo so you can start with that as a base. Normally, you can cut & paste the setup from track folder to track folder and get going, but the Evo editions will not read these non-Evo setups. There is a quick edit that will save you entering in all the parameters manually. So, copy across your preferred setup to the new Evo's setup folder.
To make the folder structure easier, I have already created all the folders for all the cars and track combos which can be found here:
ACC Setup Folders for v1.6.1
Open the setup of the car's .json in notepad and edit this first line of code
to read
and save.
The Ferrari just needs the _evo added too.
Now load the setup in-game, go to Aero section, click rear ride height up one click, then down one click and save the setup. This applies the code for the 2020 track BoP type and corrected the Rods etc adjustments. You are now good to go.
To make the folder structure easier, I have already created all the folders for all the cars and track combos which can be found here:
ACC Setup Folders for v1.6.1
Open the setup of the car's .json in notepad and edit this first line of code
Code:
{
"carName": "mercedes_amg_gt3",to read
Code:
{
"carName": "mercedes_amg_gt3_evo",and save.
The Ferrari just needs the _evo added too.
Now load the setup in-game, go to Aero section, click rear ride height up one click, then down one click and save the setup. This applies the code for the 2020 track BoP type and corrected the Rods etc adjustments. You are now good to go.
