I’m about to mount SC2 Pro to P1-x front mount.
In SC 2 manual it says to use flat washers, but they included grooved ones(with ribs on one side).
So I’m not sure which washers are better.
Also how tight should the screws be torqued? Is it better to use a lot(but reasonable) of force to be sure it won’t become loose?
In SC 2 manual it says to use flat washers, but they included grooved ones(with ribs on one side).
So I’m not sure which washers are better.
Also how tight should the screws be torqued? Is it better to use a lot(but reasonable) of force to be sure it won’t become loose?
Last edited:
