crossed circuit

[ALVAZ]

Hi everybody, i have a problem with fast path in a circuit I m doing, that is, it is a crossed circuit, one secction cross another, with a bridge, like suzuka, I hope you to understand, so the problem is that when the fast path try to pass throught the upper section it goes up, pass, over the upper section, and then goes down again to join to the track again, how can i solve this?

Thannk and kind regards

 

[chub_pearson]

It's a bug in the BTB AIW generation I'm afraid, it always does this with crossovers. You need to redo the paths using the rFactor AIW editor.
When doing this it's best to redo all the paths, as mixing paths from BTB and rFactor AIW editors can cause problems as they don't quite match up.

 

[ALVAZ]

Hello, thank you very much chub, i did not want to use the "old rFactor AIW editor", I had the expectation that the problem could be solved by BTB, but..... it was not posible
Thanks again

Best Regards