I have the URD mods for assetto corsa and love them. Is it worth me buy them for rf2 as well? How does it compare to AC. How is the egt mod in comparison to the BES 1.0 mod?
Hello David,
Directly taken from Porsche:
"As the rules do not permit higher output engines, the engine for the 991 RSR was taken from the 997 GT3 RSR 4.0 and the development work focused on the chassis, body, aerodynamics and the gearbox. A wishbone front suspension replaced the McPherson struts used in 997. A new development is the lightweight gearbox. One of the priorities in the development was the more evenly balanced weight distribution. The centre of gravity is lower, too. The front and rear lids, doors, underbody, wheel arches, rear wing, dashboard and centre console are constructed from carbon fibre. The minimum weight of the car is set by the rules and this forms a barrier for further enhancements."
So the weight distribution of a GTE and GT3 are quite different, the GTE has a lower CG, the GTE being more balanced than the GT3 and easier to drive.
Cheers.
.But I still believe that in real world, a works Porsche GTE has an incredible road holding (perfect tuning) and isn't significantly harder to drive at the limit for a professional driver than a Ferrari F458, if not the results of endurance races would be very different.
They are a lot better in rF2 than AC, dunno if someone already mentioned it, but I was too lazy reading 2 pages ;-).I have the URD mods for assetto corsa and love them. Is it worth me buy them for rf2 as well? How does it compare to AC. How is the egt mod in comparison to the BES 1.0 mod?
Ill check which I have and let you know.P.S.
Drove the Blancpain 911 just after URD at Sebring.
I agree with you, it's a pleasure to drive (much less understeer). But the undertray catches invisible objects on the track (at least the version I have 1.5, and not at every lap), in the esses before the main straight. I tried a setup which rode higher but it still occurred from time to time. Do you have a version not affected by this problem?
Thanks.Ill check which I have and let you know.
No I havent, thanks for the idea. I will try it.Hello David,
did you try to adjust the weight distribution of the darche in the setup-settings? It allows you to set the weight distribution form 44:56 up to 39.5:60.5. I personally drive the Darche with a 40.5:59.5 setting and it drives in my opinion very darchy.
By the way i think URD should set the front-heaviest (default) value up to 42:58.
Regards