Issue exporting track to rFactor.

[SmashingPants67]

Hi guys, i've discovered that the "old" issue exporting long tracks is only to rFactor.
I've tried Racer and RBR and it exported normally. But when i exported to rFactor it shown the "Can't export. Error in the application" message.

Sorry if i've a bad english. I'm a very proudly Brazilian

 

[Lee Knight]

I think when I had Error in application it was due to two nodes occupying the exact same co-ordanents...
I've exported some HUGE tracks at times & not had many problems going into rF except for the doubled node & that includes a 219km/136mile point-to-point track...
And no, that track wasn't a straight or simple road, it's got plenty of corners & hills...
http://www.mediafire.com/folder/wlxe1ogtiy9ey/Oxely_Highway

 

[liquido]

In my experience I can´t export 3d models to Rfactor if these have more than 5.000 polys (aprox) and also you set it as driveable or collidable... RBR and Racer has no problem with big meshes