Name of this connector.

[north]

What's the name of this type of connector? (It is on the AccuForce slip ring.) Thanks.

 

[Old & Slow]

What's the name of this type of connector? (It is on the AccuForce slip ring.) Thanks.

View attachment 404409

Looks like a Molex connector.

 

[north]

Looks like a Molex connector.

Thanks, problem is to find the spesific type that I have.

 

[Old & Slow]

Thanks, problem is to find the spesific type that I have.

I would contact AccuForce and ask them for the type. If they aren't responsive contact the folks at Molex.com.

 

[north]

I would contact AccuForce and ask them for the type. If they aren't responsive contact the folks at Molex.com.

Thanks. I did contact SimXperience but they couldn't help. Will check out molex.com.

 

[JimLee]

Does not look like any molex board connector I have ever seen due to the locking tab bar ..... you will also need to measure the pin pitch to help you determine the right connector.

 

[north]

Does not look like any molex board connector I have ever seen due to the locking tab bar ..... you will also need to measure the pin pitch to help you determine the right connector.

Thanks. Yeah,I could not find anything like it over at Molex, or any where else for that matter, so I'm thinking of just replacing them with something readily available.

 

[Fat-Alfie]

Is it a Molex Sherlock?

 

[north]

Is it a Molex Sherlock?

Thanks but not that one either.

Pitch is 1 mm so these are small.

 

[mechsicko]

Thanks but not that one either.

Pitch is 1 mm so these are small.

Ok, was waiting to hear the pitch because that determines a lot here. Not sure how you measured, but it's determined from center to center on the pins if you're measuring and you need calipers and a good eye to lock that down. That said, it looks like it might be a custom variant of a CViLUX connector, which are available in 1mm pitch.. like perhaps an OEM extra locking version of this connector

https://www.cvilux.com/product?id=162&level=pitch&text=1.00mm&product_id=1335


More likely it's 1.25mm pitch though and it's one of these made by the same folks:

CviLux Connector

www.cvilux.com

 

[north]

Ok, was waiting to hear the pitch because that determines a lot here. Not sure how you measured, but it's determined from center to center on the pins if you're measuring and you need calipers and a good eye to lock that down. That said, it looks like it might be a custom variant of a CViLUX connector, which are available in 1mm pitch.. like perhaps an OEM extra locking version of this connector

https://www.cvilux.com/product?id=162&level=pitch&text=1.00mm&product_id=1335


More likely it's 1.25mm pitch though and it's one of these made by the same folks:

CviLux Connector

www.cvilux.com

Thanks, looks like we're getting somewhere. And yes, looks like 1.25 from center to center. I measured it wrong the first time. I have downloaded Cvilux's catalogue to see if I can find a # to go with what I have. Thanks again.

Edit: CI40 series per the catalogue.