Replace Fanatec V1 V2 pedals connector

[fux]

Hallo,
I need to replace the connector of my fanatec v1 pedal from load cell to PCB. I post 2 photos of the cable connector. The small connector (connection to pcb board) should be JST ZH 4 PIN 1.5 but I don'tk know wich type of connector is the one on the other end of the cable (connection to load cell)???
The cable is identical to the ones connecting the accelerator and clutch hall sensors to pcb.
The two connectors look the same in shape, obviously they have the same number of pins (4), but they have different dimension sizes
Can you please help me? thanks

 

[WhippyVan]

it is just the next sized up JST 2.0mm if I remember correctly.

 

[fux]

it is just the next sized up JST 2.0mm if I remember correctly.

Hi, Yes correct!. I've just verify that it's JST PH 2.0mm
Then the cables from PCB to HALL SENSOR BOARD (accellerator and clutch) and from PCB to HALL SENSOR AMPLIFIER (BRAKE) have JST PH 4 PIN in one side and JST ZH 4 PIN in the other side.