Hey guys, I have a T300 coming tomorrow, so I'm just wondering what I should do to revert to default ffb settings after using wheel check and LUTgenerator. I have a DGFT right now, and while the new LUT feels great, it's obviously not going to work for the T300. To any of you who may have done this, how do I go about this without making a mess of things? Thanks!
Revert to Default Settings after using LUTgenerator?
This is the default ff_post_process.ini contents.
[HEADER]
VERSION=1
TYPE=GAMMA
ENABLED=0
[GAMMA]
VALUE=0.5
[LUT]
CURVE=crazy1.lut
you can find a default backup copy of it in \where ever you installed steam\Steam\steamapps\common\assettocorsa\cfg
you should also reset the controller settings in the game and then go through the normal controller set up and adjust the settings until you are happy with the results
Hope this is helpful
[HEADER]
VERSION=1
TYPE=GAMMA
ENABLED=0
[GAMMA]
VALUE=0.5
[LUT]
CURVE=crazy1.lut
you can find a default backup copy of it in \where ever you installed steam\Steam\steamapps\common\assettocorsa\cfg
you should also reset the controller settings in the game and then go through the normal controller set up and adjust the settings until you are happy with the results
Hope this is helpful
