Hello,
Ive got a problem with Thrustmaster T300 servo base. Before wheel was calibrating properly and all seemed to be fine, but to make sure that all is good I started recalibration process with "Angle Motor Calibration" app. After a few minutes of moving in all directions there was an information "Stall detected". I waited a few minutes more but nothing other happened, still the same statement. So I closed this and started once again. Now when I try to calibrate it, it says "Pre-Calibration not Found". What does it mean? Firmware is updated, services also have latest version. Right now when I plug wheel to PC its doing random short moves once per few secs and never stops this process. Im afraid that I broke this wheel with calibration software... Also drivers right now doesnt recognize wheel state, I mean what possition it has.
I do calibration process without wheel on the base and with PS3 switch on - as manual says. PC Win 10.
Do u have any ideas?
Ive got a problem with Thrustmaster T300 servo base. Before wheel was calibrating properly and all seemed to be fine, but to make sure that all is good I started recalibration process with "Angle Motor Calibration" app. After a few minutes of moving in all directions there was an information "Stall detected". I waited a few minutes more but nothing other happened, still the same statement. So I closed this and started once again. Now when I try to calibrate it, it says "Pre-Calibration not Found". What does it mean? Firmware is updated, services also have latest version. Right now when I plug wheel to PC its doing random short moves once per few secs and never stops this process. Im afraid that I broke this wheel with calibration software... Also drivers right now doesnt recognize wheel state, I mean what possition it has.
I do calibration process without wheel on the base and with PS3 switch on - as manual says. PC Win 10.
Do u have any ideas?
