Vocore Data Display Unit

[RedBull48]

Hello all,

I have recently just converted from using a nextion 4.3" display to a Vocore display for my race data feed. I designed and printed my own housing which is compatible with Fanatec devices. I figured I would share these with anyone interested in using them. They have been designed to use 4 - M3x4x5mm threaded inserts on the front plate and has 4 - M3x12mm screws hold the enclosure together from the back.

 

[ruben.laso]

Hi,
just what I needed. Thanks!
I installed it a couple of days ago in a CSW 2.5, and it fits nice. I would suggest making the clips to bolt it into the base a little longer to adjust the high better. Feels a bit low in the CSW 2.5 + Formula wheel for my taste.

 

[RedBull48]

Hi,
just what I needed. Thanks!
I installed it a couple of days ago in a CSW 2.5, and it fits nice. I would suggest making the clips to bolt it into the base a little longer to adjust the high better. Feels a bit low in the CSW 2.5 + Formula wheel for my taste.

Thanks for the feedback, I really only use this with a formula rim so I could see extra length being beneficial. How much would you like it extended by?

 

[ruben.laso]

Thanks for the feedback, I really only use this with a formula rim so I could see extra length being beneficial. How much would you like it extended by?

I would extend them by 2cm-2.5cm, I think that would give a wide range for the people to place the screen to their taste

 

[RedBull48]

I would extend them by 2cm-2.5cm, I think that would give a wide range for the people to place the screen to their taste

I have updated the model with a 2cm extension to start. If you would still like it longer let me know.

 

[ruben.laso]

Thanks! I'll give it a try as soon as I can

 

[ruben.laso]

After the summer break, I've found some time to print the new case. It's just perfect.
Thanks again!

 

[RedBull48]

Very nice, glad to help out a fellow sim racer