Alright, round two of feedback.
- The IWC Schaffhausen logo on the FW endplate could be a little bigger
- The AMG logo on the headrest could be moved up a little bit (very very nitpicky here, I know
)
- The Qualcomm Snapdragon logo should be bigger
- The numbers on the engine cover fin should be bigger and also moved closer to the edges of the fin
- Not too sure about the Petronas PRIMAX logo yet, maybe increase its size just a little bit
- The placement of the Epson logo on the RW endplate could be adjusted a bit (move it a bit backwards)
- The Crowdstrike logo is a lot bigger on the real car but I guess you kept it smaller so that the logo doesn't get messed up by all those RW endplate slots, maybe you can just play around a bit more with the size and placement to find the best compromise
- There's a mysterious third logo on the bottom of the RW endplate, couldn't figure out what it actually is, maybe you have more luck with that
- There's a small 'FW10' logo on the bargeboard, maybe you can fit it on there somehow
About the Halo: right now the black/carbon is the dominant color while on the real car it's more like 50% silver and 50% black (side view).
The black color also 'wraps' around the headrest more on the real car (There's a lot of black next to the AMG logo)
A few points about the blue/green stripe on the side:
1. I think there's too much of that blue glow around the stripe overall, there's only little glow around the stripe on the real car, it looks 'cleaner'/sharper.
2. There's too much black shading above the blue stripe on the side of the monocoque.
There should be the blue stripe, a bit of black shading and above that the Silver color should also be visible.
The Petronas logo on the side should be bigger and also moved upwards a bit. There should be more space between the logo and the blue stripe (the Petronas logo is actually on the same level as the Petronas logo on that side cockpit wing (no idea how that winglet construction is actually called
)
The framing of the letters on the Petronas logo should be silver instead of white, just had a very clear shot of it while watching FP3.
The drivers numbers on the front of the car aren't dark enough, right now it's like a dark grey while they are pitch black on the real car.
Just noticed that the wireframe is kind of peeking through on the Mercedes logo on the Halo...?
Ok, this is the absolute final point I will make here.
I think that the black shading on the early part of the engine cover fin is a bit too strong if you compare it to the shading of the actual engine cover below.
Ah, I guess you're already aware of it but don't forget that 'E' logo below the Qualcomm Snapdragon logo.
Damn, this feedback turned out to be longer than I expected, sorry.
But I hope it is somewhat helpful.
