Michael Krone
Premium
So the last week, maybe two my back to pits button isnt working properly. Its both teleport to pits, and setup in pits.
I either have to press it several (10+) times or hold it for 5-10 seconds.
In the controls menu in AC/CSP and windows calibration menu it shows every press/hold properly.
Normally my teleport to pits button is on my wheel and setup in pits is on a button box. I can swap pit buttons all over from the wheel buttons to my button boxes, this only happens with these two commands so it is 100% not a hardware issue.
Anyone have any ideas? Thanks!
I either have to press it several (10+) times or hold it for 5-10 seconds.
In the controls menu in AC/CSP and windows calibration menu it shows every press/hold properly.
Normally my teleport to pits button is on my wheel and setup in pits is on a button box. I can swap pit buttons all over from the wheel buttons to my button boxes, this only happens with these two commands so it is 100% not a hardware issue.
Anyone have any ideas? Thanks!
Last edited:
