F1 2013 Fanatec CSR Setting advice

[Phil Dawson]

Hopefully somebody can shed some light on this.

Using a fanatec CSR wheel, I notice that wheel on screen does not match the input I make with the wheel, however, it feels like my wheel input is correct. So essentially, it's as if the motion in game and my wheel is correct, but the onscreen wheel doesn't, sometimes only turning very slightly even though I am at 90degrees with the wheel.

If I use the game settings and tell it to override my wheel then the wheel and screen match, however the FF feels weak and poor, the steering lock is also quite weak too.

 

[Gavin Hendley]

Try messing around with steering linearity in game settings think mine is around 30-40.
Try SEN off see if that improve FFB, I find FFB quite bad on this game anyway.

Have a look here
http://www.racedepartment.com/forum/threads/fanatec-recommended-wheel-settings.75169/#post-1533694

 

[Phil Dawson]

That's where I copied my settings from.

I do however, only have access to ffn strength and wheel weight, if select to override the wheel options.

At which point the ffb is very weak, with a steering lock that you can go past before it pulls it back to the lock a fraction after you have already steered past it.

 

[Kent Bergstrom]

Here is my Xbox 360 settings (I use Elite pedals)

Fanatec CSR Settings

SEN = 330
FF = 90
SHO = 100
DRI = Off
ABS = 85
LIN = 0
DEA = 0
SPR = -2
DPR = -3
ACL = Off

In Game Settings
Steering Deadzon = 0.50
Steering Saturation = 0
Steering Linearity = 0
Throttle Deadzone = 0
Throttle Saturation = 0
Brake Deadzone = 0
Brake Saturation = 10

Force Feedback

Environmental Effects = 100
Feedback Strenght = 100
Wheel Weight = 20