How to calibrate Fanatec Clubsport v3 brake pedal in Dirt Rally?
- Thread starter Elaphe
- Start date
You need to calibrate (set the desired pressure for 100% brake input) it in the windows controller settings first (or in the wheelbase onboard settings if your pedals are connected to the CSW/CSL wheelbase). Read the manual for the pedals, it is explained there (9.1.1 PC driver – page ‘Function Test’).
Upvote
0
But my pedals must be correctly calibrated already because in Assetto Corsa, for instance, I have to push the brake really hard to reach the max. Could this problem has to do with brake gamma?
Upvote
0
Brake saturation is already set to 100%. With that 100% is reached when the pedal is pressed 80% aprox. If I lower brake saturation, the problem increases and 100% is reached even sooner. If I increase brake saturation the problem, apparently noticed in the Dirt menu, is that the bar never reaches 100%. For instance, if I set saturation to the max value, the brake bar only reaches 67%. I don't undestand this.
Upvote
0
I'm not sure what you mean by "pressed 80%" and how you measured it. Brake pedal does not have a hard stop (well it probably has, but you gotta be a Hulk to reach it). And max pressure is set via control panel/wheel profile.It should be the same regardless of the game you play.
I checked my pedals and the pressure I apply to get 100% in DR seems to match the one I need to apply for 100% braking in AC. My brake gamma in AC is 1.0 and DR does not have a similar option as far as I remember.
I checked my pedals and the pressure I apply to get 100% in DR seems to match the one I need to apply for 100% braking in AC. My brake gamma in AC is 1.0 and DR does not have a similar option as far as I remember.
Upvote
0
