Hello.
After putting in the real world wheelbase, track and ride height for some cars, the tires are sticking out the sides and rubbing the front and rear fenders. I measured the models and discovered they are not scaled correctly, up to 18 inches too short in length and 3 inches too narrow in width.
Is there a way to 'easily' resize the models to their correct dimensions? Do you know how to do this and would you like to help get them scaled to their real world dimensions?
I am aware that I can use the suspension.ini [GRAPHICS_OFFSETS] section to alter the x-axis locations to give the appearance that wheels/tires are located closer to the center of the model to keep them from sticking out the sides but am not aware of a z-axis adjustment to alter the wheelbase graphically to keep the tires from rubbing the fenders.
Ideally, I would like the cars to be the correct dimensions but will settle for not having the wheels rubbing the fenders.
If you can give assistance on how to resize the models, would like to help with getting it done or know how to make the wheelbase appear shorter to fit the too short models, please let me know.
I am working on 1960s and 1970s American cars from the Trans Am, Grand American, Grand National and Winston Cup series, some of which were originally made for or have been converted from NR2003, thus, the smaller size to fit the NR2003 collision box.
Thank you for any help with this.
After putting in the real world wheelbase, track and ride height for some cars, the tires are sticking out the sides and rubbing the front and rear fenders. I measured the models and discovered they are not scaled correctly, up to 18 inches too short in length and 3 inches too narrow in width.
Is there a way to 'easily' resize the models to their correct dimensions? Do you know how to do this and would you like to help get them scaled to their real world dimensions?
I am aware that I can use the suspension.ini [GRAPHICS_OFFSETS] section to alter the x-axis locations to give the appearance that wheels/tires are located closer to the center of the model to keep them from sticking out the sides but am not aware of a z-axis adjustment to alter the wheelbase graphically to keep the tires from rubbing the fenders.
Ideally, I would like the cars to be the correct dimensions but will settle for not having the wheels rubbing the fenders.
If you can give assistance on how to resize the models, would like to help with getting it done or know how to make the wheelbase appear shorter to fit the too short models, please let me know.
I am working on 1960s and 1970s American cars from the Trans Am, Grand American, Grand National and Winston Cup series, some of which were originally made for or have been converted from NR2003, thus, the smaller size to fit the NR2003 collision box.
Thank you for any help with this.