My DIY pedals

[RickD]

Finished my DIY pedals. Wilwood pedals, mastercylinder and slave cylinder. Transducers, 1.000psi break and 300psi clutch. Bodnar 12-Bit BU0836A board, Throttle P261P-D1BS3CB10K, several 3D printed parts. Laser cut custom steel plates, extra throttle 3mm piano wire spring. Excellent break pedal feel due to the double slave cylinders that make many spring combinations possible. After 100 hours of racing in my sfx-100 motion rig I'm still super happy.

 

[Mr Latte]

Looks good, excellent work. Do you have a link to the washers used or are they just M8?

 

[RickD]

Looks good, excellent work. Do you have a link to the washers used or are they just M8?

Thanks and yes, they are standard M8 washers.

 

[Swood24]

Awesome pedals. I have these pedals and want to do a hydraulic setup as well. But I have no clue on how to do it.

 

[Michael Krone]

Jeez those look good. Nice job.

 

[7HUND3R]

I have the same wilwood slave cylinders, what size of flexible hose connector do you connect?