New Fanatec driver (222) and firmware

Hi all, installed the new Fanatec driver on a Windows 10 64 bit edition. It comes with a new firmware as well (csw v1) but when I start the update it says the hex file can not be loaded. Anybody an idea?
 
It could be also about W10, I still use W7 64bit. So you mean that it doesn't say that fw/hex-file preloaded, or when it actually try to update wheel's memory? You use same usb-slot as normally with wheel?
 
Upvote 0
Had trouble too after I upgraded to W10 as well. W10 seemed to have trouble finding the wheel - but removing the drivers and reinstalling them worked fine. Upgraded the firmware, good to go. Hope that may help,

Fritz
 
Upvote 0
Back
Top